|
QuickSkin - New from Zyvax, Inc. |
|
|
QuickSkin has been developed for use in making molds or parts from machinable tooling block of any density. QuickSkin supports rapid prototyping of masters and/or production of a limited number of parts.
QuickSkin cures in minutes at room temperature and is applied by roller or brush to a clean, dust-free surface. 2-6 coats may be needed depending on porosity with only 15 minutes cure time between coats.
Cured film is usable up to 275° F. (135° C.) and can be repaired if damaged. QuickSkin does not require any post-curing.
QuickSkin Datasheet & MSDS
Contact
This e-mail address is being protected from spam bots, you need JavaScript enabled to view it
for more information.
|
|
|
ZYVAX ANNOUNCES CERTIFICATION |
|
|
|
Zyvax, Inc. has received its certification under ISO 9001:2000 and AS9100:2004 Rev. B. 
Zyvax’s certification scope is: Design, Manufacture, and Distribution of Mold Release Products for Aerospace and Other Industries.
Zyvax is especially proud to have its WaterWorks Aerospace Release System included under the AS9100:2004 Rev. B Certification in compliance with the needs of the aerospace community. WaterWorks continues to capture the attention of aerospace manufacturers, with the only completely solvent-free product line able to meet important aerospace standards while offering critical performance in the advanced composite molding environment. In addition to AS9100 Certification, WaterWorks remains the only aerospace release system with California’s AQMD (Air Quality) approval.
|
|
Read more...
|
| |
|
|
|
<< Start < Prev 1 2 Next > End >>
|
| Results 1 - 4 of 5 |
